Worx Trimmer Line Does Not Feed. Back when we bought our house we knew we needed a string trimmer to edge the lawn and reach tight spots a mower will miss. Beside this, what size line does the worx trimmer use?
Reassemble the head parts in reverse order. Push the retainer into the center. To replace this lever, remove the trimmer head cap then remove the spool.
You may have to remove the trimmer head cover and manually feed line through the port. If the automatic feed still isn't working, repeat these disassembly steps and remove and replace the entire cutting head. After some research at the time we wound up going with the worx 20v battery powered string trimmer (affiliate link).
Keep your trimmer as far away from the grass as possible. Wind the line around the spool. I make sure only 0.5 to 1 inch of line (i.e.
The tip) comes in contact with the grass. Visit our string trimmer repair help for more troubleshooting information and repair videos: Feed the free end of the line through the eyelet in the trimmer head and push the spool back into the head.
If the trimmer line is too thick or too thin for the trimmer head, the trimmer line won’t feed. I have to stop and take the inner reel off and pull out more line. This lever is located inside the trimmer head and works on centrifugal force, feeding out more line as the line wears away.
The trimmer line won’t feed. Sliding the spool back to the shaft. So the trimmer engine is running smoothly and the trimmer head is spinning… and, yet, no new line is coming out of the head.