Kenmore Undercounter Ice Maker Troubleshooting. If you have unrestricted reach to the ice machine at this point, you can begin removing the arm. The ice maker won’t make cubes if the freezer is too warm.
Let 24 hours pass after steps are complete and check for ice production. Simply grab it, lift it a little, and pull it out. 2.is the water supply connected?
Bad or defective ice maker this mechanical icemaker is used in many different refrigerators such as; I recieved this ice maker from my grandpa, who said he put the unit in clean mode and never would come out of it. Plug in the unit and press the “on/off’ button.
The water filter must be replaced every 6 months to maintain proper water flow and more importantly, the quality of water. I drained the water, turned it on, the reservoir fills up but the main pump will not run for a normal ice making cycle. Check the water supply line for damage, pinching, or kinks.
If that fixes your problem (of course it will not drain now), then you need a. A dryer, steamer, or some warm water should do. If you notice that the freezer door gasket is damaged, leaky, cracked or the seal has loosened.
Is the control set to on? It comes integrated with the ice maker wire harness, in case you need to order it: There is plenty of ice being made.
E) test the inlet switch and the inlet valve. Your ice maker may not be able to keep up with its intended rate of production when the refrigerator or freezer temperatures are set too high, but temperatures too low can also lead to small or hollow cubes. I have a kenmore under counter ice maker model 6.89483998 that seems to have excessive water from the drain in the rear.