Sony Str Dn1050 Zone 2. An additional audio system (for example, an amplifier) to output the sound in zone 2. 7 x 95 watts (6 ohms, 2 channels driven).
* for a connection using the hdmi zone 2 out jack only. I want to be able to adjust the volume separately for each zone while playing the same audio, but can't figure out how. Into 4 ohms, the amplifier reaches 0.1% distortion at 136.8 watts and 1% distortion at 167.0 watts.
Select the source signals you want to output in [ zone2 input ]. This sony receiver does a pretty good job in making older 1080p and lower resolution content look good in big 4k tvs. For example, you can watch a dvd in the main zone, while others can listen to a cd in zone 2 at the same time.
Hdmi 2.0 is supported too so 4k videos look great at 60p. Select [ source] if you want to listen to the same sound as main zone in zone 2. And sony of canada ltd.
The zone 2 feature allows this receiver to send a second source signal to a separate audio system in another location. Sony phone support was less than helpful, suggesting hdmi cables might be the issue. The dn1050 will be in a closed cupboard under the stairs with a ir blaster next to it and i need to be able to switch to and from 'zone 2' just using the remote without the need to press any buttons on the actual receiver.
To use this feature, you need: To use this feature, you need: An additional audio system (for example, an amplifier) to output the sound in zone 2.
Apple tv, dvd, etc.) although it's just speaker wire, it seems it does not output the digital signal. * for a connection using the hdmi zone 2 out jack only. Sony raises the bar once again tested at £500.